User`s manual

CBI-1010
4-12 Setup
4 At the statement WRITE DATA TO THE DEVICE? <Y OR N> enter N to
immediately send the command if SCSI command does not require a
data
out phase.
Or enter Y to send data to the device after the command phase if SCSI
command requires a data out phase. Enter the data and enter [ESC] to
terminate editing. The statement
SAVE EDITED DATA IN BUFFER?
<Y OR N> will appear. Enter Y to save data in the buffer; or enter N to
erase edited data after the command is sent.
Testing SCSI Device
Selection 'T' can be used to read only, write and read selected disk drive,
and/or write and read selected tape drive continuously. This is a diagnostic
tool to help
with installation and testing. Follow the procedures below to test
the
SCSI device.
1 Enter T from the
/I Additional Utilities" menu. (Be sure you have
correctly selected either 5 from the main menu for disk drives, or 7 for
tape drives.)
2 At the question DEVICE NUMBER? DEV <0-6> enter the device number.
3 When testing for disk devices, at the statement READY TO TEST THE DEVICE
DO YOU WANT TO READ ONLY? <Y OR N> enter Y to read only or N to
read and write. If you selected N, the question ARE YOU SURE? will
display. Enter Y to
read and write to the device.
WARNING Nwill destroy all data on the device.
When testing for tape devices, the statement ARE YOU SURE? will display.
Enter Y
to test the device.
4 The test will continue until you abort. Allow the test to continue for a
few minutes' for new devices and ten minutes for suspected bad devices.
Press
[BREAK] or [CTRL] + C to abort and exit back to the main menu.