User`s manual

CBI-1010
(DUX SCSI ID? <0-7> J
~_D_U_X_L_U_N_?_<_O-_3_> ____________________________________ __
Figure 4-7: Disk and Tape Configuration Change
NOTE This LUN is SCSI LUN; it is normally O. This is used
only for devices that support multiple LUN's.
6
When you have completed these instructions the display will show your
current configuration and prompt you again with the question CHANGE.
CONFIGURATION? (YIN). Enter N; this will cause the CBI-lOlO to scan the
SCSI bus.
The utility will display
your current configuration with manufacturer's
name, model number, and firmware revisions for each device.
Sending SCSI Commands To The Device
Selection'S' can be used to send SCSI commands to the selected disk/tape
drives directly.
This option is
used to send a 6-, 10-, or l2-byte command to a SCSI device.
Follow these procedures to send SCSI commands to the device:
1 Enter
S from the "Additional Utilities" Menu. (Be sure you have cor-
rectly selected either 5 from the Main Menu for disk drives, or 7 for tape
drives.)
2
At the question DEVICE NUMBER? DEV <0-6> enter the device number.
3 Enter the
command sequence at the statement:
READY TO TEST DEVICE X
EDIT CDB <HEX>
***<ESC> TO TERMINATE EDITING***
BYTE 0000= 00
If a 6- or la-byte command is used, press [ESC] to terminate command
editing. If a l2-byte command is used, command editing is terminated
automatically.
Setup 4-11