User`s manual

CBI-1010
4-10 Setup
3 To reconfigure the device select option C and the screen will prompt
you
with the following question as shown in Figure 4-5.
WARNING Use homogeneous high quality twisted pair cables within
SCSI specifications for 5-MB/sec transfer rate.
Enter Synchronous transfer rate (MB/sec)
Enter
(4-10)
Figure 4-5: Synchronous transfer rate change
4 Enter synchronous rate from 4 to 10 MB/sec. The screen will prompt
you to answer the next series of questions as shown in Figure 4-6.
Enter Initiator ID 7
Number of Disks?
(0-7) 4
DUO to be Reconfigured ? (YIN) N
DU1 to be Reconfigured? (YIN) N
DU2 to be Reconfigured? (YIN) N
DU3 to
be Reconfigured? (YIN) N
Number of Tapes?
(0-3) 3
MUO to be Reconfigured? (YIN) N
MU1 to be Reconfigured? (YIN) N
MU2 to
be Reconfigured? (YIN) N
Figure 4-6: SCSI host adapter 10 change
5 Enter Initiator SCSI ID 7 or the required Host Adapter SCSI ID (default
is
7). Enter the number of disk and/or tapes. Default configuration is
four disks,
and three tapes; it is not necessary to configure if running
fewer than four disks
and three tapes.
NOTE If zero is selected for the number of disk or tapes, place
a
shunt over the appropriate pins on jumper WI. See
Table
3-2 on page 3-3.
Answer
Y or N to reconfigure each of the disks or tapes. If you answer
Y, the screen will prompt you with these questions: