User`s manual

CBI-1010
M = Toggle Density Mode R = Toggle SCSI Reset
D
= Toggle Disconnect
S = Toggle Sync/ Async
C = Reconfigure Device
Q = ToggieTMU
B = Toggle BufferlTruncate Mode (Tape/Disk)
W
= Toggle DensitylWrite Verify Mode (Tape/Disk)
P
= Toggle Prevent Medium Removal (Disk only)
F = Toggle Fast File Search(Tape only)
G = Toggle FMT
U = Toggle Default Tape (Tape Only)
A = Autoboot Start From Floppy Drive
N = Write Protect from Controller Jumper Setting
V
= Truncate Disk Size for Volume Shadowing
E = Eject Disk after Dismount
L
= Reserve/Release Disk Option
J = Change Selection Timeout Period
T = Reset All Device Modes to Default
Z
= Reset Controller to Default Configurtation
(Hit <return> key to exit)
Figure 4-4: Configuration change
The following list is an explanation of the selections in Figure 4-4.
R
= Toggle SCSI reset-Choosing this option will toggle the controller's
ability to issue SCSI resets. This should be turned off when multi-hosting
is desired.
D
= Toggle Disconnect-This option allows you to enable or disable
disconnect for each device. If disconnect is enabled, the controller will
indicate its ability to disconnect during the SCSI identify message.
S = Toggle SyndAsync-This option allows you to configure each
device for synchronous or asynchronous operations. If synchronous is
selected, the controller will attempt a synchronous message exchange
with the device. If the device accepts the message exchange, they will
transfer data synchronously, otherwise they will transfer asynchronously.
C
= Reconfigure Device-This option allows you to reconfigure each
device.
Q = Toggle TMU-This option allows you to configure the controller
for tape monitoring.
It is used in conjunction with licensed software that
will display tape statistics. If enabled, a pseudo unit of 255 will appear
during a VMS show dev command.
Setup 4-7