User`s manual

CBI-1010
4-6 Setup
To display SCSI devices and set up configuration follow the procedures below.
1 Select option D at the sub-menu (Figure 4-2), the following current
configuration is displayed as shown in Figure 4-3.
DEVO DUO, SCSI ID 0, LUN 0
Disconnect ON, Sync Mode ON, Prevent Medium Removal ON, Write WNerity OFF
DEV1 DU1, SCSI ID 1, LUN 0
Disconnect ON, Sync Mode ON, Prevent Medium Removal ON, Write WNerity OFF
DEV2 DU2, SCSI ID 2, LUN 0
Disconnect ON, Sync Mode ON, Prevent Medium Removal ON, Write WNerity OFF
DEV3 DU3, SCSIID 3, LUN 0
Disconnect ON, Sync Mode ON, Prevent Medium Removal ON, Write WNerity OFF
DEV4 MUO, SCSI ID 4, LUN 0
Disconnect ON, Sync Mode ON, Prevent Medium Removal ON, Buffer Mode ON
DEV5 MU1, SCSI ID 5, LUN 0
Disconnect ON, Sync Mode ON, Prevent Medium Removal ON, Buffer Mode ON
DEV6 MU2, SCSI ID 6, LUN 0
Disconnect ON, Sync Mode ON, Prevent Medium Removal ON, Buffer Mode ON
DEV7 SCSI ID 7, HOST ADAPTER SCSI Reset ON, Tmu OFF, Fast Search OFF, sync rate=4-
mb, Density Mode ON, Default Tape OFF Boot Floppy OFF, Jumper Write Protect OFF,
Eject Disk ON, Truncate Size OFF, Rsv/Rls Option ON, Sel Timeout=250 msec
Figure 4-3: Current configuration, default
NOTE If Truncate Size is toggled, IITruncate Mode ON" will
display
under each disk device options and at the bot-
tom when configuration is displayed.
2 To change the configuration, enter
Y at the statement: CHANGE
CONFIGURATION?
(YIN). The menu shown in Figure 4-4 will display.
NOTE See subsection, IIUnit Numbering" before trying to re-
configure devices.