User`s manual

CBI·1010
Displaying SCSI Device and Setting Up Configuration
Selection 'D' can be used to change the controller default configurations such
as those listed below:
• reset to default
• number of disk and tape devices supported
• SCSI ID of the CBI-IOIO
• SCSI reset enable / disable
• SCSI disconnect enable/ disable
• sync/async mode selection
• tape buffer mode enable/ disable
• prevent medium removal enable/disable
• disk write with verify enable/disable
• Tape Monitor Utility (TMU) enable/disable
• Tape Fast Search enable/disable
• SCSI transfer rate selection
• remote density mode enable/disable
• default tape enable/disable
• reconfigure device
• autoboot start from floppy enable/disable
• write protect from controller jumper setting
• truncate disk size for volume shadowing
• eject removable disk cartridge after dismount
This utility can also
scan/display the SCSI devices attached to the CBI-IOIO.
The CBI-IOIO/TM will be shown as an example in the following display.
Setup 4-5