User`s manual

CBI-1010
4-4 Setup
4 The monitor will display QUALIFY STARTED <SEQUENTIAL WRITE AND
READ>! <HIT <BREAK> TO ABORT>.
5 The monitor will display TESTING LOOP COUNT AND BLOCK NUMBER:
6 Press [BREAK] to exit back to the main menu after you are satisfied with
the qualifying process.
Manually Replacing Bad Sectors
This option allows you to replace bad sectors manually. The controller
supports dynamic defect management which replaces defective sectors on-line
so there is no need to manually replace bad sectors. However, if you wish to
replace bad sectors manually follow these instructions; remember that any
data in the sector will be lost:
1 Select option 4 from the
main menu.
2 Enter the device number at the statement: DEVICE NUMBER? DEV <0 TO 6>:
3 Enter the logical block number in HEX at the statement: ENTER THE BAD
BLOCK NUMBER <HEX>:
4 The monitor will display -BAD BLOCK REPLACED- when finished
executing.
Additional Utilities
To access additional utilities for disk drives, select option 5 from the main
menu. To access additional utilities for tape drives, select option 7 from the
main menu. The additional utilities menu will display as shown in Figure 4-2.
ADDITIONAL UTILITIES (REV. YVYxZ2.) SN = 1278X
D = DISPLAY SCSI DEVICE AND SET UP CONFIGURATION
S
= SEND SCSI COMMAND TO THE DEVICE
T = TEST SCSI DEVICE
R = FORMAT RCT BLOCK
SELECT
OPTION?
Figure 4-2: Utility Sub-menu