User`s manual

CBI-1010
3 At the statement: SAVE NEW CONFIGURATION (Y or N)? enter Y.
4 The monitor will display COMPLETE when finished executing.
Formatting the Drive
This section details formatting a drive. The CBI-IOIO issues Format Unit
Command to the selected SCSI disk drive and requests it to map out the
defects
on the Manufacture Defect List (MDL). Remember formatting a drive
will rewrite all the sectors of that drive.
CMD recommends that you format all new drives. To format a drive, follow
the steps below:
1 Select option 2 from the main menu.
2 Enter the device
number from 0 to 6 in the statement: ENTER DEVICE
NUMBER 0 TO 6 :
3 At the statement: *** WILL DESTROY DATA ON DEVICE X, ARE YOU SURE? en-
ter Y if you want to continue.
4 The monitor displays
WAIT while the drive is executing the format
process.
5 The monitor will display COMPLETE when finished executing.
Qualifying the Drive
After formatting the device, CMD recommends you qualify devices by
running this procedure at lease once without errors detected. The qualify
program writes different patterns to the drive and then verifies the data. If
there are any bad sectors, the sectors will automatically be replaced and the
statement
XX XXXXXXXX BAD BLOCK REPLACED will appear. Follow the
instructions below for qualifying a drive.
1
Select option 3 from the main menu.
2 Enter the device
number at the statement: QUALIFY DEVICE NUMBER
<0 TO 6>:
3 At the statement: *** WILL DESTROY DATA ON THIS DEVICE, ARE YOU SURE?
enter Y if you want to continue.
Setup 4-3