User`s manual
CBI-1010
Single-Ended Mode
The CBI-I0I0 is factory configured to user specifications. However, if
you
need
to convert the CBI-I0I0 from differential to single-ended, follow these
instructions.
1 Remove the differential SCSI daughter card (CBI-I012) from the
lower
left
comer
of the CBI-I0I0 board.
2 Install the single-ended SCSI
daughter
card (CBI-I0ll)
at
the same loca-
tion of the CBI-I0I0 board. Make sure to align
Jl
of the
daughter
card
with
Jl
of the CBI-I0I0 board. See figure 3-5.
J1
J2
Figure 3-5: Single-Ended Card (CBI-1 011) Installation
Figure
3-6
illustrates the components of the
CBI-I0ll
single-ended
daughter
card. The terminator resistors are located
at
RNI
and
RN2.
3-8
Installation