User`s manual

CBI-tOtO
CPU
--~~ DID~fmml .. ' 3
'---~ 1 ( 1"---_.(, ___ "II~-~
~_-_~ __ (::::::::::3 (:::::::3 (:::::::3(::::::::::1
- (:::::::3 - 1 ~ 1 4 ~ I J
....---.. ~::=::::{ IDI:::::::::::.:~ :::::::::::::~:::::::~ ~:::::::~
'---_--' (:::::::3 .::::::::::::3 C:::::::::::I:::::::3 (:::::::3
1:::::::::::3 (:::::::3~~1~:::~:::~::~::~::3~~~~~~~~~
1:::::::::::3 '---- ... _-.,....... ........ (:::::::3
~c::J D" II IIII II C:::::::3
~ (:::::::3
(:::::::3
D
~
<
<
U9
VUlt
CHIP
c::J c::J c:::::>
D
--1.:::m!ll!!lIIIl111mDJ ~---,<r=~1 ,
(::::::::3 (:::::::3 (:::::::3 (:::::::J
(:::::::3 (:::::::3 C:::::J C::::::::::3
C:::::3
C3 q~W8::J
JE
(:: :::::< '--------'
Figure 3·1: Components of the CBI·1 01 0
Disk and Tape Emulation Selection for the CBI-1 01 O/TM
The CBI-IOIO/TM is a multiple function controller. When you configure the
CBI-IOIO/TM as a single function controller (configured through RS-232 Util-
ity as 0 disk or 0 tape) the unused function must be disabled. You can disable
one of the functions
shown below, see Table 3-2 for different configurations.
• To disable tape function, install a shunt on pins I and 3 of jumper WI.
See Figure 3-2 for location of WI and pin positions.
• To disable disk function, install a shunt on pins 2 and 4 of jumper WI.
See Figure 3-2 for location of WI and pin positions.
3-2 Installation