User`s manual

3
Installation
This chapter details hardware configuration and installation for the CBI-1010.
The CBI-1010 must be configured first, installed in the system second, and
SCSI devices installed last. This chapter is organized in the order the CBI-1010
must be installed; after completing hardware installation, refer to "Setup" in
Chapter 4. Features not selectable here can be selected through the On-Board
Utility
in Chapter 4.
Hardware Configuration
This section details setting up various features for the CBI-1010 before install-
ing it inside a system. Be sure to follow the instructions listed in each subsec-
tion for
proper configuration. Table 3-1 illustrates the default settings for each
CBI-1010 model.
Table 3-1
Default Settings
Model
Wl(1-3) Wl(2-4) W5(1-2)
U9
CBI-IOIO/TM
OUT
OUT
OUT
PAL PIK08
CBI-IOIO/T
OUT
OUT
OUT
PAL PIK28
CBI-IOIO/M
OUT OUT
OUT
PALPIK29
CBI-IOIO/MB
OUT OUT
IN
PAL PIK58A
Note that (F) means factory setting.
Figure 3-1 illustrates the components on the CBI-1010.
Installation 3-1