User`s manual

CBI-1010
CBI-1 01 0 Specifications
Table 2-4 on the following page lists the Controller Specifications for the
CBI-IOIO.
Table
2-4 Controller Specifications
Emulation
Bus Interface
Adapter
Size
Interrupt Vector
Transfer Mode
Command Queuing
Data Buffer Capacity
Defect Management:
Software Supported
Multiple-Hosting
Formatting
Optional Software
LED Indicators
Peripheral Interface
SCSI Transfer Rate
SCSI Bus Parity
Devices Supported
System Performance
SCSI Driver/Receiver
SCSI Cable Length
Operating Temperature
Relative Humidity
Power Requirement
MSCP (DU driver) / TMSCP (TU driver)
VAXBI
Single V AXBI slot
Software programmable
Octaword DMA master
32 Commands with optimized seek
Virtual data buffer
Dynamic defect management
VMS, ULTRIX and selected UNIX versions
Support multiple-hosting for disks, optical drives and tapes.
On board format and bad block replacement (ISO standard
for optical erasable disk format)
Tape monitor utility
(TMU)
Self test, error conditions, single-ended SCSI enable, single-
ended terminator power, differential
SCSI enable,
differential terminator power
Small Computer System Interface (SCSI)
10.0-MB/sec in Synchronous mode
7.0-MB/sec in Asynchronous mode
Odd parity
Up to 7 SCSI devices
Support disconnect/reconnect capability and multiple host
configuration
Single-ended or differential
Single-ended,
up to 9.9 ft (3 meters) recommended at
10 MBytes / second transfer rate
Differential,
up to 80 ft (25 meters)
5° C to 50° C
10% to 900/0 , Non-condensing
+5V DC 6.0A, +12V DC 14mA, -12V DC 6mA
Features and Specifications 2-5