Owner`s manual

Getting Started
2.1.4. Detergent dispenser.
The machine is equipped with detergent dispenser, which automatically draws the product.
Detergent has been pre-wired prior to the shipment. Refer to wiring diagram on the page 8 for
deterg
ent dispenser connection.
Chemical output line is connected to the injecto
r on the back of the machine. Insert chemical
input line with the filter in detergent container. Prime detergent dispenser and proceed to
dispense. Detergent dispenser capacity can be adjusted using a screwdriver. Every 13/16 inches
(2 cm) of product drawn into chemical line corresponds to 0.25 cc.
2.1.5. Temperature Adjustments.
Booster heater temperature adjustment always has priority over that of the wash tank, and both
cannot be switched on at the same time. During wash pump operation the wash tank heating
element doesn’t work.
If necessary, the water temperature of the wash an
d rinse cycles can be adjusted by means of
the fine adjustment screws on the respective thermostats located on electric component panel.
The recommended temperatures are 160°F (71 °C) for the wash cycle (tank) and 180°F (82,2°C)
for
the rinse cycle.
2.1.6. Drain Pump.
The machine is equipped with a drain pump. Pay particular attention the position of the drain
hose, which should not be higher than 31 inches (0.8 cm). To empty the wash tank turn off the
machine by pressing the main switch, pull out the overflow tube inside the water tank and leave
the door open. Than keep manual drain button pressed until water tank is completely empty.
During the Wash/Rinse cycle, excess water will automatically be drained.
MODEL UC50e INSTALLATION & OPERATION MANUAL Rev. 1.00A Page
4