Owner's Manual
Table Of Contents
- 1. Specifications
- Getting Started
- 2.1. Introduction to CMA-180
- 2.2. Receiving and Installation
- 3. Wiring Options
- Quick service guide
- 5. INITIAL PARTS KIT P/N 1100.17
- 6. Auto-Fill Solid State Timer
- 7. Wire Diagram for CMA-180 With Booster Heater
- 8. Wire Diagram for CMA-180 Booster Only
- 9. Wire Diagram for CMA-180 Without Booster Heater
- 10. Wire Diagram for 480V 180 Without Booster Heater
- 11. Wire Diagram for 480V 180 With Booster Heater
MODEL CMA-180 INSTALLATION & OPERATION Rev. 2.08A Page
7
2.2.4. Exhaust Fan Control Kit p/n 17528.00 Instructions
1. Connect terminal #1 on timer block (Red) to heater contactor terminal marked L3
2. Connect terminal #3 on timer block (Blue) to heater contactor terminal marked L1
3. Connect terminal #2 on timer block (Red/Black) to fan contactor coil terminal.
4. Connect terminal #3 on timer block (Blue) to other fan contactor coil terminal
5. Connect terminal # 3 on timer block (Blue) to sixth cam top terminal on timer assembly.
6. Connect terminal #6 on timer block (Blue) to sixth cam middle terminal on timer
assembly.
7. Connect power source of 220 Vac or 110 Vac to L1 and L2 (N) on fan control contactor.
8. Connect exhaust fan motor to T1 and T2 on other side of fan control contactor.