Owner`s manual

Maintenance
MODEL GLC/GW-100 SERVICE & PARTS MANUAL Rev. 1.02 Page9
PROBLEM LIKELY CAUSE SOLUTION
Moisture, condensation,
wet areas behind service
door
Pump seal leaking Replace
Detergent tank drain screen
plugged
Clean
Primary drain plugged Clean
Rinse water drain line backing up Clear obstruction, clean machine
Return screen in soap detergent
tank plugged
Clean
Covers on detergent tank are not
installed properly causing
condensation
Position all top covers to
completely cover top of tank
Wheel not turning Power off at circuit breaker Reset circuit breaker
Drive motor defective Replace
Micro switch on switch support
bracket faulty or not making
contact
Replace or make adjustment to
switch
Conveyor not engaged with drive
gear
Position properly.
Low or no pressure
coming from wash arms
No or low water in soap tank
Check water supply
Check tank stand pipe position
Check that fill switch is in On-Fill
position and that tank fills with
water
Check float switch operation
Check hot fill solenoid is
operational
Obstruction in wash arm
Clear obstruction
Wash Pump not running Check power supply
Check pump capacitor
Replace pump
Pump running but no pressure to
wash arms.
Inspect the impeller
Replace if needed
Water spraying out
conveyor entrance
Spray arms not locked in place
Spray arms must be pushed firmly
on to hub connection on spray
base
Spray arms plugged Clear and clean with cleaning drill,
scraper, and brush
Splash curtain not in position Install or adjust
Machine in operation without any
glasses on conveyor
Operate machine with a full load of
glasses