Owner's Manual

Getting Started
MODEL AH, B & C INSTALLATION & OPERATION MANUAL Rev. 1.01A Page
9
Ask your municipal water supplier for details about your local water conditions prior to installation.
Recommended water hardness is 3 grains per gallon or less.
Note: high iron levels in the water supply can cause staining and may require an iron filter. High
chlorine levels in the water supply can cause pitting and may require a chloride removal system.
If an inspection of the dishwasher or booster heater reveals lime buildup after the equipment has
been in service, water treatment is recommended. If water softener is already in place, ensure there
is a sufficient level of salt.
Technical personnel are available during normal business hours at CMA Headquarters should you,
as an installer, have any questions please call 800-854-6417.
2.2.3. Connecting the Scrap Accumulator and Drain
The scrap accumulator is designed to perform two basic functions:
1. It allows all the heavy solids to discharge out of the machine with each wash cycle and
collect in a clean out tray.
2. It provides accumulation capacity to allow draining the contents of one cycle regardless
of the discharge rate of the existing drain.
The drain pipe is connected to the scrap accumulator drain using a 2” no-hub connector (not
supplied) as shown in
Figure 2.2.3 below.
Figure 2.2.3