User Manual

P/N: 192047082 (REV AA) 627NH January 2018
22
IMPULSE•G+ MINI STRUCTURE OF PARAMETERS
Frequency Reference Setting
Sets/Displays the drive operation speed (Hz).
Output Frequency Monitor
Displays the output frequency (Hz.) at which the drive is currently operating. This is a monitor only function; the operator cannot change the
displayed value by use of the keypad.
Output Current Monitor
Displays the level of output current (Amps) that the drive is currently producing. This is a monitor only function; the operator cannot change
the displayed value by use of the keypad.
Monitor Selection
Pressing ENTER allows access to the various Monitor parameters. These are monitor-only functions; the operator cannot change the
displayed value. Accessible during run command. See pages 21 thru 26 for complete listing of all monitor parameters.
*Parameter Programming
Selects or reads data using parameter settings. Data is displayed by pressing the ENTER key, and can be changed by pressing the “up
arrow” or “down arrow” keys. Any changes can be saved by again pressing the ENTER key. Pressing the ESC key exits the programming
mode.
Output Voltage Monitor
Displays the level of output voltage to the motor. This is a monitor only function: The operator cannot change the displayed value by use of
the keypad.
User
Allows for quick access to parameters that can be programmed by operator.
*Note: All programming parameters are password protected, except those stored in user function..