Service manual

UCW and Ultraview 1700 Monitors — Service Manual
5-8
01030A06 “Video could not detect blue video signal” Replace CPU board.
01030B00 “Couldn’t open IRTS device driver”
Reboot and retest. If problem
persists, replace CPU board.
01030B01 “IRTS interface failed” Replace CPU board.
01030B02 “IRTS ring board interface failed” Replace CPU board.
01030B03 “IRTS IR pair failed”
Re-calibrate the touchscreen and
retest. If problem persists,
replace IRTS board/bezel.
01030B04 “IRTS reset failed” Replace CPU board.
01030B05 “IRTS change mode failed” Replace CPU board.
01030B06 “IRTS uP RAM failed” Replace CPU board.
01030B07 “IRTS uP ROM failed” Replace CPU board.
01030B08 “IRTS data dump failure” Replace CPU board.
01030B09 “Interactive IRTS test failure” Replace CPU board.
01030B0A “IRTS ALU error” Replace CPU board.
01030B0B “IRTS Remote Keypad ALU error” Replace CPU board.
01030B0C “IRTS ALU warning status, please calibrate”
Re-calibrate the touchscreen and
retest. If problem persists,
replace IRTS board/bezel.
01030C00 “OS error while diagnosing KBD”
Reboot and retest. If problem
persists, replace CPU board.
01030C01 “Can’t access KBD device registers” Replace CPU board.
01030C02 “KBD didn’t respond to command” Replace CPU board.
01030C03 “KBD failed selftest” Replace CPU board.
01030C04 “KBD failed interface test” Replace CPU board.
01030D00 “Can’t access AUDIO device registers” Replace CPU board.
01030D01 “Could not open audio device”
Reboot and retest. If problem
persists, replace CPU board.
01030D02 “Audio device didn’t respond correctly” Replace CPU board.
01030D03 “Audio Loopback test failed” Replace CPU board.
01030E00 “NVRAM Test Failed” Replace CPU board.
01030E01 “NVRAM Clock Not Running” Replace CPU board.
01030E02 “NVRAM Checksum error”
Zero the NVRAM and reboot. If
problem persists, replace CPU
board.
Table 1: Diagnostic Failure Messages (continued)
Error Code Diagnostics Failure Message Suggested Action