Service manual

UCW and Ultraview 1700 Monitors — Service Manual
4-22
Enclosure Removal
1. Remove the four painted screws from the top of the unit.
2. Remove the four screws and two feet from the bottom of the unit.
3. Slide the right and left enclosure halves away from the bezel and off the unit chassis.
4. Reverse the removal procedure to reassemble the enclosure.
Bezel Removal
1. Remove the enclosure according to the enclosure removal procedure.
2. Remove the four screws that secure the bezel to the chassis.
3. From the right side of the unit, slide a flat blade screwdriver between the bezel and the
chassis and deflect the lower snap attached to the center web of the bezel.
4. From the left side of the unit, slide a flat blade screwdriver between the bezel and the chassis
and deflect the upper snap attached to the center web of the bezel.
5. Pull the bezel away from the chassis.
6. Reverse the removal procedure to reassemble the bezel.
Rear Panel Removal
1. Remove the battery and enclosure according to their respective removal procedures.
2. Remove the PCBA Drawer assembly according to its removal procedure.
3. Remove the six screws and six connector jackscrews from the rear panel.
4. Pull the rear panel away from the chassis.
5. Reverse the removal procedure to reassemble the rear panel.
Backplane PCBA Removal
1. Remove the enclosure, battery, and rear panel according to their respective removal
procedures.
2. Gently remove the output connector section of the PCBA from the plastic standoffs attached
to the main PCBA section and rotate away from the main PCBA.
3. Remove the power interconnect cable from the main PCBA.
4. Remove the six screws that secure the main PCBA to the chassis.
5. Pry the upper-left and lower-right corners of the main PCBA from the chassis snap-standoffs
and remove the PCBA.
6. Reverse the removal procedure to reassemble the backplane PCBA.