Service manual

UCW and Ultraview 1700 Monitors — Service Manual
4-18
Touchscreen Removal/Reassembly
Removal
1. Insert a blade screwdriver (or similar object) into each of the two slots, one at a time, located
on the underside of the bezel.
Figure 4-8: Touchscreen removal
2. Gently pull the front bezel away, (with an upward pressure) from the display assembly and
tilt upward.
3. Pull the bottom of the touchscreen out just far enough to allow disconnection of the serial
interface cable leading to the I/O PCBA.
4. After disconnecting the serial cable, lift the touchscreen assembly up and away from the unit.
Reassembly
1. Reattach the bezel by inserting the three hooks located at the top of the front bezel into the
top slots of the secondary bezel. Tilt the front bezel downward, being careful not to damage
the ribbon cable.
2. Reattach the ribbon cable.
3. Push in on the assembly until the touchscreen locks into place.
bottom view