Service manual

UCW and Ultraview 1700 Monitors — Service Manual
4-14
PCBA Drawer Removal/Replacement
Removal of the PCBA drawer requires that both the CPU and I/O PCBAs be removed as a unit.
Figure 4-4: PCBA drawer removal
To extract the PCBA drawer:
1. Remove all external cables from their connectors.
2. Remove the screws (refer to Figure 4-5 below) that attach the rear panel to the monitor.
Figure 4-5: Screw placement for drawer assembly
3. Pull the drawer assembly completely out of the monitor.
To reassemble the PCBA drawer:
1. Slowly reinsert the drawer assembly, being careful to align the PCBA sides with the slots
inside the monitor.
2. Push the drawer completely in to ensure that the connectors on the front of the PCBA
become fully inserted.
panel, rear, primary
I/O PCBA
interconnect PCBA
CPU PCBA