Service manual

UCW and Ultraview 1700 Monitors — Service Manual
4-12
Figure 4-2: Location of screw
5. Return the monitor to its normal position.
6. Remove the CRT top cover using the top cover removal tool (P/N 003-0085-00).
a. Locate the two latches that hold the bezel and top cover together (refer to Figure 4-3 on
page 4-13).
b. Position the top cover removal tool next to the two latches (refer to Figure 4-3 on
page 4-13).
c. Firmly push down on the top of the rear cover near the bezel and insert the removal tool
between the bezel and top cover as far as possible.
d. Slide back the rear cover from the bezel by grasping the cover on both sides and
sharply pushing in and back.
bottom view