Service manual

UCW and Ultraview 1700 Monitors — Service Manual
4-8
Display Alignment
1. At the Main menu, touch MONITOR SETUP, and then touch PRIVILEGED ACCESS.
2. Enter the password using the on-screen keyboard and touch ENTER.
3. Touch MONITOR CALIBRATION.
4. Touch CRT POSITION.
The display will show the following:
Figure 4-1: CRT positioning
These keys can be used to move the display up, down, left, and right as well as to stretch or
compress the display horizontally and vertically.
Touch the BORDER key for a border to appear around the screen perimeter. However, the current
screen adjustment may be such that portions of the border may be positioned off-screen. Adjust the
screen position and the size until the entire border is visible and is positioned as close to the edge of
the display as possible. This is the optimum screen position adjustment.
CAUTION:
• Repositioning the screen does not change where the IR touchscreen
expects each key to appear. If the screen size or position is severely altered,
significant misalignment of the key images and the true physical
touchscreen keys may occur.
BORDER