Service manual

UCW and Ultraview 1700 Monitors — Service Manual

2-24

SELECT RECORDERS Key

The SELECT RECORDERS key enables you to assign a priority to system recorders for each bed

(where nnnnn is the bedname).

Touching this key displays the following menu:

1. Touch one of the above keys to display a list of available system recorders.

2. Touch the recorder name key assigned to the bed as either primary or secondary

(depending upon your choice in step 1).

3. Touch PREVIOUS MENU to return to one of the Select Priority menus.

4. Repeat steps 1 through 3 to assign the remaining recorder(s).

Serial Ports Menu

Use this menu to define the communication parameters for the serial port and to assign it to a

specific application (Diagnostics or Data Logger option).

To set the serial port’s communication parameters:

1. From the Biomed menu, touch the SERIAL PORTS key.

2. Select a serial port key.

3. Verify that the SETTINGS and ASSIGNMENT keys appear.

4. Touch the SETTINGS key to display the following keys (factory defaults are in bold):

DATA BITS — Selects the number of data bits (6, 7, or 8).

PARITY — Defines the type of parity checking used (EVEN, ODD, or NONE).

STOP BITS — Defines the number of stop bits required (1, 1.5, or 2).

ECHO — Defines the echo mode to be used (NONE, FULL, LOCAL, REMOTE).

CR/LF — Defines the carriage return/line feed mode (INPUT, OUTPUT, FULL, NONE).

XON/XOFF — Sets the XON/XOFF controls (ENABLE or DISABLE).

BAUD RATE — Defines the baud rate setting (1200, 2400, 4800, 9600, 19,200, or 38,400).

5. Set each key in this menu to match your serial port’s communication requirements.

• The Auto selection considers paper usage in determining the destination of the

recording. The Backup selection always selects the primary recorder, unless it is

either unavailable or unable to print the recording.

BACKUP

RECORDER BRECORDER A

Select priority of recorder to be assigned to nnnnn

when the SELECTION key is set to BACKUP

when the SELECTION key is set to AUTO

PRIMARY