Service manual

UCW and Ultraview 1700 Monitors — Service Manual
2-22
SUBNET ACCESS Key
The SUBNET ACCESS key limits the monitor’s accessibility to beds physically located on other
subnets. When Subnet Access is OFF, the monitor can access only those beds attached to its own
subnet. When Subnet Access is ON, the monitor can also access beds located on other subnets.
To set Subnet Access to OFF:
1. Touch the SUBNET ACCESS OFF key.
2. Power the monitor OFF and ON again to ensure that all alarm watches, zone assignments,
and remote views are cleared.
3. Set the remote views (bedside monitors) as desired.
4. Select Recorders using only the recorders on the local subnet and set Preselected
Recordings to access only the monitors in the local subnet.
5. Set alarm watches as desired.
Preselected Recordings Menu
The Preselected Recordings menu enables you to define which beds and parameters are
automatically recorded when the user touches the PRESELECTED A and PRESELECTED B keys
in the Recorder menu.
To define the PRESELECTED A and B keys:
1. Touch PRESELECTED RECORDINGS to display the keys:
2. Touch the key to be defined (A or B). The following keys appear:
SELECT TYPE enables you to choose which parameters for the selected bed(s) will be
recorded.
SELECT BED enables you to choose which bed(s) will have the selected parameter sent to
the recorder.
3. Touch SELECT TYPE to display the following menu:
This menu enables you to choose to record either the first few parameters for the bed, all
the parameters on this bed, or only specified parameters.
4. Touch ALL BEDSIDE PARAM(S).
5. Use the ARROW keys to cycle through the parameter selections: ALL BEDSIDE PARAM(S)
or FIRST N BEDSIDE PARAM(S) (where n is 1, 2, 4, or 8).
PRESELECTED A
Select configuration to change
PRESELECTED B
SELECT
TYPE
SELECT
BED
Select option to change
ALL
BEDSIDE PARAM(S)
CONFIGURED
PARAMETERS
Select recording type