Service manual

UCW and Ultraview 1700 Monitors — Service Manual
2-4
Figure 2-1: 90385 base tension adjustment
Wall Mounting
Figure 2-2: Bedside configuration
!
• If necessary, base adjustment must be done prior to installing the monitor onto a
mount.
• Not all monitors will have the base tension adjustment described here.
!
• Specific wall requirements for the installation of wall mounts are not covered in
this manual and are the responsibility of each hospital. Refer to the Module
Housings and Power Supplies Service Manual (P/N 070-0680-xx, located on
CD-ROM 084-0700-xx) for detailed instructions.
base tension adjusting screw
minimum of 60”
from floor
Ethernet connector
AC mains
10’ patient cable
patient bed
route all power cables
inside the wall track
90385, 91415, or 91418
90491 or 90387
power supply