Service manual

Introduction
1-5
Example:
A 90385-XFQ (where “X” represents the language designator) is an UCW equipped with:
• Q = Data Shuttle option
• F = Four waveform zones
Accessory devices supported by the UCW/1700 are as follows:
Modules — Supports all existing Ultraview modules except 90425, 90428, 90432, and 90410. Use
of modules in conjunction with the UCW requires a module housing(s) and DC power supply(s);
whereas, the Ultraview 1700 provides plug-in support for either two single-height modules or one
double-height module. Additional modules are supported by means of external module housings.
Flexport
®
system interfaces — Supports the use of all existing Spacelabs Medical Flexport
interfaces. Refer to Setup on page 2-1 for installation requirements.
Repeater Displays — Up to two repeater displays may be connected. The repeater displays serve
only to duplicate the information shown on the Ultraview monitor and does not accept user input.
Repeater displays may be located up to 100 feet from the Ultraview monitor.
Touchscreen — The Ultraview 1700 supports the ELO Touch brand touchscreens. The UCW uses
an integral infrared touchscreen.
Mouse — Supports the use of a PS/2-style mouse.
Keyboard — Supports the use of a PS/2-style keyboard.
Nurse Alert — Supports the use of a Spacelabs Medical nurse alert device. This device provides an
external indication that one of the parameters being monitored is in an alarm condition.