Owner`s manual

CM Labs SixtyFour Owner’s Manual Page 9
Operations
Save.
Save program data to the internal memories by:
1. Press the SAVE switch on front panel once. This
enters the save mode. The yellow LED next to the SAVE
switch will flash, and the numerical display will have the
letter “P” in the first position.
2. Rotate the encoder knob to select the desired memory
location.
3. Press the SAVE button a second time.
All routes and level settings are then saved for all 32
sources and destinations.
There is no “undo” function at this point in the procedure,
nor is there a “revert to last saved” function, so be sure
that information is correct before saving.
Exit “Save”.
If you want to exit “save” mode without actually saving,
press any of the other 3 command switches or press the
rotary encoder knob and you will exit the “save”
mode and undo all changes made to the program
Undo.
Remember, when you are in any of the command modes
(route, utility or level) and you make some changes but
decide you don’t wish to save those changes,you can
undo those changes by simply pressing the encoder knob
before you have pressed the “save” button the second
time. This will undo the changes you have just made and
return the program memory to the previously saved
settings.
C. Master/Slave.
Shows as either NST or SLV in numeric display. Simply
turn the rotary control knob until the desired choice
appears in the numeric display. Since several SixtyFour’s
can be joined together to form a large system, the first
unit in the chain must be master and all following units
must be slave. Be aware that all setup procedures
such as assigning, routing or stereo pairs must still be
executed on each unit in the chain. Once the system is
set up, you can control all units in the chain via the
master’s rotary control knob or the host computer.
When the SixtyFours are locked, you can preview
program memories. When units are unlocked, you
canpreview and recall program memories. This allows
you to operate all the units in the chain from the master’s
rotary control knob.
D. Meter Sensitivity.
1. In Utility Mode, push rotary control knob until “sen”
scrolls through the numeric display.
2. At this point - turn the rotary control knob and the
choices “+ 4” or “-10” will appear.
3. Make your choice now and then exit utility mode by
pressing the two buttons labeled “Level” and “Meter”.
E. Set Locks
These are the “One Patch Lockout” and “Overall
Lockout”.
1. In Utility Mode, push rotary control knob until “loc”
scrolls through the numeric display.
3. At this point - turn the rotary control knob and the
choices “Off”, “One” or “All” will appear.
4. Make your choice now and then exit utility mode by
pressing the two buttons labeled “Level” and “Meter”.
*Note: Regarding saving this information, in utility mode -
only patch maps must be manually saved. All other
programing information is automatically saved at