Owner`s manual

Operations
Page 8 CM Labs SixtyFour Owner’s Manual
B. Stereo Pairs.
Shows as STE in the numeric display. Factory default is
no stereo pairs assigned.
TWO WARNINGS!
1.) Only adjacent Sources and Destinations can be
assigned as stereo pairs. You can assign #1 & #2 as a
stereo pair, but you cannot assign #1 & #3 as a stereo
pair. Additionally, Sources or Destinations 16 and 17
cannot be assigned together as stereo pairs.
2.) When routing, stereo Sources can only be assigned to
stereo Destinations.
Stereo Sources.
To define stereo Source pairs (in Utility Mode):
1. Press the left channel Source switch (which lites that
LED) and then the right channel Source switch. Both
LED’s will now be on to indicate that a stereo pair now
exists.
2. Push the rotary control knob to exit or to assign further
stereo pairs.
3. To confirm assignment, press either Source switch,
and both LED’s will light up indicating they are now a
stereo pair.
4.) If you wish to unlink them at this point, press the right
channel switch and they will be unlinked.
Repeat steps 1 and 2 above to define more stereo
Sources.
Stereo Source levels.
Once a stereo Source has been defined, the pair will use
the left channel level setting to control the level of the
stereo pair.
Stereo Destinations.
To define stereo destination pairs (in Utility Mode):
1. Press the left channel Destination switch (which lites
that LED) and then the right channel Destination switch.
Both LED’s will now be on to indicate that a stereo pair
now exists.
2. Push the rotary control knob to exit or to assign further
stereo pairs.
3. To confirm assignment, press either Destination
switch, and both LED’s will light up indicating they are
now a stereo pair.
4.) If you wish to unlink them at this point, press the right
channel switch and they will be unlinked.
Repeat steps 1 and 2 above to define more stereo
Destinations.
Stereo Destination levels.
Once a stereo Destination has been defined, the pair will
use the left channel level setting to control the level of the
stereo pair, and the right channel as the stereo balance
setting. If the right channel setting was at unity gain, it will
now be at Left 40, and not Center. You will need to reset
the balance to unity for each memory.
To do this, power the unit on and hold down the Save,
Route, Level and Meter switches while the ROM version
is being displayed. You will see “CLR NEN” scroll across
the display and then all 90 memories will be cleared. This
will set levels to unity gain and set stereo balance to
center. All 90 program memories will be ready to go.