Owner`s manual

Installation & Quickstart
Page 4 CM Labs SixtyFour Owner’s Manual
6.) Push in the encoder, and notice that all the routes you
made were just undone.
7.) Press the LEVEL switch to enter level mode. Press
SOURCE 1 switch to select source 1. The display now
shows the level setting (in dB Gain) for source 1.
8.) Rotate the encoder to change the level setting of
source 1.
9.) Press DESTINATION 1 switch to select destination 1.
The display now shows the level setting (in dB Gain) for
destination 1.
10.) Rotate the encoder to change the level setting of
destination 1.
Troubleshooting
If your SixtyFour does not respond properly please Email
us at [e-mail] and let us know the
nature of the problem and your phone number. We’ll do
our best to get you going in a hurry.
Audio Interconnect.
The SixtyFour has 8 DB25 female connectors on the rear
panel for all the audio inputs (sources) and outputs
(destinations). Each DB25 connector carries 8 balanced
audio inputs or outputs. Connect your audio devices to
the SixtyFour by 2 methods.
1.) Standard DB25 audio snakes. Simply connect the
snakes to the SixtyFour rear panel and tighten the screws
included with the snakes. Each DB-25 connector is fully
compatible with “Tascam” style snakes and connectors.
2.) The CM Labs DB-8 terminal strip adaptor. Wire the
DB-8 up according to the pin connections given on it.
Use the (+) and (G) connections to hook up single ended
(unbalanced) devices to the SixtyFour. Since the
SixtyFour has gain control, you can level match unbal-
anced to balanced devices.
Pinout:
Channel Pin Signals
1 , 9 , 17 , 25 24 ,12 , 25 + , - , GND
2 , 10 , 18 , 26 10 , 23 , 11 + , - , GND
3 , 11 , 19 , 27 21 , 9 , 22 + , - , GND
4 , 12 , 20 , 28 7 , 20 , 8 + , - , GND
5 , 13 , 21 , 29 18 , 6 , 19 + , - , GND
6 , 14 , 22 , 30 4 ,17 , 5 + , - , GND
7 , 15 , 23 , 31 15 ,3 , 16 + , - , GND
8 , 16 , 24 , 32 1 ,14 , 2 + , - , GND
Quick Start.
1.) Power on the SixtyFour. Both the “SAVE” and
“ROUTE” LED’s will blink in unison to show that it is “Soft
Locked”.
2.) Press the SAVE and ROUTE switches together to turn
soft lock off.
3.) Press in the Encoder and rotate until it says “P 5” and
release it. You have just recalled memory # 5. The
memory is not actually recalled until you release the
encoder.
4.) Press the ROUTE switch to enter route mode. Press
SOURCE 3 switch to select source 3.
5.) Press DESTINATION 1 switch. You have just routed
source 3 to destination 1. You will notice that the decimal
point is blinking to indicate that the current settings are
different from memory # 5.
CM Labs DB - 8 audio adaptor