Owner`s manual

Serial Control Specifications
Page 16 CM Labs SixtyFour Owner’s Manual
*Master/Slave Read MIDI Patch Map Rx BN-6D-7F
*Master/Slave MIDI Patch Map Rx, Tx BN-6D-00
BN-6E-Patch (Chan1)
Note: If Patch = 7F Then it is Off BN-6E-Patch (Chan2)
BN-6E-Patch (Chan3)
...
BN-6E-Patch (Chan16)
*Master/Slave Read label Rx BN-6F-Source or Dest+20
*Master/Slave Label Rx, Tx
BN-Source or Dest+20 CHAR 0
BN-Source or Destination+20 CHAR 1
BN-Source or Destination+20 CHAR A
Note: Char Is ASCII Character
*Master/Slave Store current Settings to Patch Rx BN-70-Patch#
Master/Slave Current Patch Number Tx BN-71-Patch#
Master/Slave Blank Patch Number Tx BN-71-7F
*Master MIDI GPI on Rx, Tx, Echo B0-7F-7E
*Master MIDI GPI off Rx, Tx, Echo B0-7F-7F
*Slave MIDI GPI on Rx, Echo B0-7F-7E
*Slave MIDI GPI off Rx, Echo B0-7F-7F
Master Encoder Push Tx B0-7F-7B
*Slave Encoder Push Rx, Echo B0-7F-7B
*Slave Encoder Push Rx, (Echo if N is not mychan) BN-7F-7B
Master Encoder Release - (LOCKED) Tx B0-7F-7C
Master Encoder Release - (UNLOCKED) Tx B0-7F-7D
Master Encoder Rotate Tx B0-7F-Patch
*Slave Scroll Memory Rx, (Echo if N is not mychan) BN-7F-Patch
Master Ping Hi Tx 80-XX-01
Master Ping Lo Tx 80-XX-00
*Slave Ping Hi Rx 8N-XX-01
*Slave Ping Lo Rx 8N-XX-00
*Slave Ping Hi Echoinc Tx 8(N+1)-XX-01
*Slave Ping Lo Echoinc Tx 8(N+1)-XX-00
Note: XX = 00 if Patch edit buffer is same as Patch data (no edits in process)
Note: XX = 01 if Patch edit buffer is different from Patch data (edits in process)
Note: The decimal point on the most significant 7 segment display of a slaved SixtyFour is blinked by the ping
messages input to it.
Meter Messages
Master&Slave Audio Meter N = MIDI Channel Rx AN-Audio Chan-Value
Audio Chan is 00 to 1F for sources and 20 to 3F for destinations.
Value 00 to 0C corresponding to -30, -25,-20,-15,-1 0,-5,-2,0,+2,+5,+1 0,+20
*% Master&Slave Source Level 32 destinations from 00 to 1F Rx BO-Source-Level