Owner`s manual

Serial Control Specifications
Page 14 CM Labs SixtyFour Owner’s Manual
SixtyFour MIDI/RS232 Implementation Chart (ROM Version 1.31)
Note: All numbers in hexadecimal unless otherwise noted. Tx = Transmitted; Rx = Received
RS-232 is 38.4k Baud N, 8,1 N = Channel from 0 to F Pin3 is TX, Pin2 is Rx
Echo = Recieved and Echoed out Echoinc = Recieved and Echoed on MIDI channel + 1
Make Master/Slave selection in SixtyFour Util Mode
% = Responds only if Soft Lock Off
* = MIDI and RS232
*Master/Slave Message Tx/Rx/Echo/Echoinc Message
Lock Messages
*Master/Slave Soft Lock Off Rx BN-60-00
*Master/Slave Soft Lock On Rx BN-60-01
*Master/Slave Lock Mode Read Rx BN-61-7F
*Master/Slave Hard Locks Off Rx, Tx BN-61-00
*Master/Slave Hard Lock One (locks Memory #1) Rx,Tx BN-61-01
*Master/Slave Hardlock All (Locks Memories 1-90) Rx, Tx BN-61-02
Status Messages
*Master/Slave Status Read Rx BN-61-7E
*Master/Slave Patch Change and Save OFF Tx BN-60-06
*Master/Slave Patch Change Mode ON Tx BN-60-07
*Master/Slave Save Mode ON Rx,Tx BN-60-08
Patch Control Messages
*% Master/Slave Patch Change Rx CN-Patch (00 to 59)
*Master/Slave Request current Patch Number Rx, (Echo if N is not mychan) BN-61-71
*Master/Slave Store current Settings to Patch Rx BN-70-Patch#
*Master/Slave Current Patch Number Tx BN-71-Patch#
Mode Control Messages
*Master/Slave Route Mode On Rx BN-60-02
*Master/Slave Level Mode On Rx BN-60-03
*Master/Slave Meter Mode On Rx BN-60-04
*Master/Slave Modes Off Rx BN-60-05