Owner`s manual

Page 26 CM Labs Dashboard Owner’s Manual
Transport Switches
These switches activate the DAW basic transport func-
tions.
Jog/Shuttle Section
Jog Shuttle Wheel.
The JOG/SHUTTLE wheel has a very high resolution
(200 pulses per revolution), and is used to control both
the jog and shuttle functions of the DAW.
Shuttle and Scrub Switches.
The SHUTLE and SCRUB switches turn these functions
on and off. The ProTools will remain in shuttle or scrub
mode until either of these switches is pressed again, or
any of the transport switches are pressed.
In shuttle mode, rotating the wheel clockwise from center
shuttles the transport forward at high speed and the F
FWD and PLAY LED’s will light. In like manner, rotating
the wheel counter clockwise from center shuttles the
transport backward at high speed and the REW and
PLAY LED’s will light.
In both cases, the speed of shuttling is determined by
how far the wheel is rotated from its center point. Press
and hold the CTRL switch followed by a number switch
will enable “shuttle lock” which is indicated by the blinking
of the SHUTTLE LED. In this mode, the speed of shut-
tling is controlled by pressing any of the 0-9 number
switches with 0 being off. The + and - switches control
the direction of play. Press the STOP switch to exit
shuttle lock mode.
Zoom/navigator section.
This section has 4 unlit switches and a “mode” switch at
the center. The 4 mode LED’s are labelled “navigate”,
“zoom”, “select” and “adjust”. The mode switch cycles
through navigate, zoom and adjust modes. The table
below shows how this very powerful section operates.
Navigate/Zoom/Adjust Spreadsheet
Lower Panel Controls