Owner`s manual

Lower Panel Controls
Page 24 CM Labs Dashboard Owner’s Manual
Clipboard Switches
CUT, COPY, PASTE, DELETE.
These 4 switches each have secondary functions as well.
When the SHIFT switch is held down these become
default, assign, capture, and seperate controls.
CUT.
Pressing the CUT switch removes the currently selected
edit region and places it in the clipboard.
COPY.
Pressing the COPY switch makes a copy of the currently
selected edit region and places it in the clipboard.
PASTE.
Pressing the PASTE switch takes the clipboard contents
and copies it to to the secected tracks beginning at the
edt cursor location .
DELETE.
Pressing the DELETE switch removes the currently
selected edit region,but does not place it in the clipboard.
“default”.
“assign”.
“capture”.
“seperate”.
Edit MODE switch.
Press the MODE switch to cycle through the 4 edit
modes: Shuffle, Slip, Spot, and Grid. These edit modes
are described in detail in the ProTools owners manual.
Additionally you can hold down the MODE switch and
press a number switch (1,2,3, or 4) on Dashboard to
secect a specific edit mode.
MODE & 1 = Shuffle mode
MODE & 2 = Slip mode
MODE & 3 = Spot mode
MODE & 4 = Grid mode
Edit TOOL switch.
Press the TOOL switch to cycle through the 6 edit tools:
Zoom, Scrub, Trim, Select, Grab, Pencil. These edit tools
are described in detail in the ProTools owners manual.
Additionally you can hold down the TOOL switch and
press a number switch (1, 2, 3, 4, 5, or 6) on Dashboard
to secect a specific edit tool.
TOOL & 1 = Zoom tool
TOOL & 2 = Scrub tool
TOOL & 3 = Trim tool
TOOL & 4 = Select tool
TOOL & 5 = Grab tool
TOOL & 6 = Pencil tool
The Zoom and Scrub tools are also available on the
ZOOM switch (in the middle of the 4 navigator switched)
and SCRUB switch on Dashboard.
Clipboard Switches (4)
Edit Mode and Edit Tool Switches