Owner`s manual

BYPASS
While in Plug-in mode and displaying inserts, press and
hold SHIFT and BYPASS. Then press one of the channel
SELECT switches to bypass that plug-in.
ALL
The ALL switch is used to make changes to all channels.
For example, press and hold the ALL switch and press a
channel SELECT switch and all the channels will be
selected.
ALT/FINE
This switch is used for many things including:
PAN
Pressing SHIFT and ALT/FINE down while rotating a pan
pot will display its value numerically from -100 to +100 on
the top row of the LCD.
SEND
Pressing SHIFT and ALT/FINE down while rotating a
send pot will display its value numerically from off to
+6dB on the top row of the LCD.
FADERS
Pressing SHIFT and ALT/FINE down while touching or
moving a fader will display its value numerically from off
to +6dB on the top row of the LCD.
SCRUB
Pressing SHIFT and ALT/FINE down while scrubbing will
cause fine scrubbing.
WINDOW
Press and hold the WINDOW switch and its LED lights
up and the LCD display shows the various window
names, and the LED’s on the SELECT switches show the
status of the windows. Press the SELECT switch under
“MIX” to bring the Mix window to the foreground. Press
the SELECT switch under “EDIT” to bring the Edit
window to the foreground.
TOOLS
Pressing SHIFT and TOOLS will cycle through the edit
tools.
PLUG-IN
If both the “bypass” and “select” LED’s are off, press the
PLUG-IN switch. The Rotary Display will display either
“IN” for insert, or “PA” for parameter. Simultaneously,
MotorMate will open the currently selected plug-in. If
none is selected, See Page 16 for Plug-in operation.
COMPARE
This switch will allow the comparison of the present plug-
in parameter settings to the previous settings.
Edit and System Controls
CM Labs MotorMate Owner’s Manual Page 25
Page 26 CM Labs MotorMate Owner’s Manual
SUSPEND
Press the “SUSPEND” switch to
globally suspend playback and
recording of automation. The
LED will blink. Press again to
globally reactivate playback and
recording of automation.
CREATE
The CREATE switch is used to
create groups. First use the
SELECT switches below the
LCD to select a channel to
include in a group. Press and
hold the SHIFT switch . Press
more select switches to add
channels. With SHIFT still down
press the CREATE switch and
the Pro Tools Group dialog box
will appear. Press the ENTER
switch on MotorMix to complete
the process or ESC to exit
without grouping.
The GROUP switch and LED
under the VIEW section on
MotorMix are used to enable/
disable groups. If the LED is lit,
the groups are enabled. With
groups enabled, press and hold
the SHIFT switch then hold the
GROUP switch down. The top
row of the LCD will show the
channel group assignments.
ENABLE
Press and hold the ENABLE, and
the LCD will display “FADR MUTE PAN SEND
SENDM PLUG IN SUSP”. The SELECT LED’s will
show the current state for these enables, and the
SELECT switches toggle them on and off.
MODE
Press SHIFT and MODE on the lower panel of
MotorMate, and it will display the automation modes for
the current bank of 8 channels. You can rotate any of the
rotaries to change their automation modes.
Reset MotorMate
To reset MotorMate, press SHIFT, UNDO, and ENABLE
at the same time.