Specifications

MIDI Control Surfaces Guide72
Insertion Follows Scrub/Shuttle
Preference
How you work with CS-10’s Scrub/Shuttle wheel
depends on whether you select the “Edit Inser-
tion Follows Scrub/Shuttle” Operation prefer-
ence in Pro Tools.
If “Insertion Follows Scrub/Shuttle” is selected:
■ Press the Scrub switch or the Shuttle switch
and move the wheel to clear the current selec-
tion and move the cursor.
■ Hold down the SHIFT switch before pressing
the Scrub switch or the Shuttle switch, or before
moving the wheel, to keep the current selection.
As you move the wheel, the selection is ex-
panded or trimmed.
If “Insertion Follows Scrub/Shuttle” is not
selected:
■ Press the Scrub switch or the Shuttle switch
and turn the wheel to keep your current selec-
tion and move the cursor outside of the selec-
tion.
■ Hold down the SHIFT switch and turn the
wheel to clear the current selection and create a
new one. The new selection starts wherever you
first press the SHIFT switch.
■ Release SHIFT switch to move the cursor out-
side the new selection.
■ Press the SHIFT switch additional times to
trim the new selection as needed.
Scrub/Shuttle Tips
◆ At any time during scrubbing or shuttling you
can press the Left or Right Arrow to move the
current scrub position to the selection start or
end.
◆ You can freely move between scrub and shut-
tle modes. The current scrub or shuttle position
is retained.
◆ If you enter scrub or shuttle but don’t move
the wheel or mouse, you can exit Scrub or Shut-
tle without affecting the current selection.
To define a selection using a combination of scrub
or shuttle functions:
1 Press the Shuttle switch to enter Shuttle mode.
2 Shuttle along the timeline. When you get to
roughly the selection in-point, press the SHIFT
switch.
3 Continue shuttling down the timeline. When
you get to roughly the out-point, release the
SHIFT switch. Your “rough selection” is now de-
fined.
4 Press the Scrub switch to enter scrub mode.
5 Press the Left Arrow key to move the scrub po-
sition to the selection start.
6 Hold down the SHIFT switch (to retain your
selection), scrub the selection in-point until you
reach the desired location.
7 Press the Right Arrow key to move the scrub
out-point to the selection end.
8 Hold down the SHIFT switch (to retain your
selection), and scrub the selection out-point un-
til you reach the desired location.
To make selections in quick succession, de-
fine a selection using any of the techniques
described above, press the Down Arrow to
capture it as a Memory Location, and con-
tinue down the timeline to capture more se-
lections.