Specifications

MIDI Control Surfaces Guide70
Transport Switches
The CS-10 has five, standard transport control
switches:
◆ Rewind
◆ Fast Forward
◆ Play
◆ Stop
◆ Record
Holding down the CONTROL switch (F6) and
pressing the Record switch cycles through the
various recording modes (Loop Record, Destruc-
tive Record, and QuickPunch).
In addition, the following special modes are
supported with modifier keys:
◆ SHIFT+Play: Half-speed playback
◆ SHIFT+Rewind: Return-to-Zero
◆ SHIFT+FF: Go-to-End
◆ SHIFT+Stop: Aborts recording pass
◆ CONTROL (F6)+F9: Cycles thru master trans-
port mode (Pro Tools, Serial Machine Control,
or ADAT)
Fast Forward and Rewind Settings
If the Audio During Fast Forward/Rewind op-
tion is not selected, you can continuously re-
wind or fast forward by holding down the corre-
sponding switch. You can also rewind or fast
forward incrementally by repeatedly clicking
the corresponding switch. The size of these in-
crements depends on which Display mode is
currently selected:
◆ Bars/Beats: To start of previous or next bar
◆ Min/Sec: Moves in one-second steps
◆ Timecode: Moves in one-second steps
◆ Feet.Frames: Moves in one-foot steps
◆ Samples: Moves in one-second steps
Transport Control of External Devices
The CS-10 can be used to control devices other
than Pro Tools, such as the Alesis ADAT
®
(via
the ADAT Bridge and MMC) or serial (9-pin) ma-
chine control transports (using the Machine-
Control™ option for Pro Tools). If you have ei-
ther of these installed, the following functions
are available:
◆ To cycle through available transport master
types (Pro Tools, Serial Machine, ADAT), press
the Online switch (F9) while pressing the CON-
TROL switch (F6).
◆ The RECORD switch LED mirrors the state of
the device under control.