Specifications

MIDI Control Surfaces Guide60
4 When a menu choice is reached, you can con-
firm the assignment in one of two ways:
• Press the ASSIGN switch to confirm all of your
assignments at once.
• Press the SELECT switch beneath the insert in
the display to confirm your choice. This con-
firms the assignment for that insert, and
leaves you in Assign mode.
You can cancel at any time by pressing the
F8/Escape switch.
5 Press the SELECT switch directly under a
newly assigned plug-in, and its first control pa-
rameter page appears in the display for editing.
You can switch between viewing insert selec-
tions and parameter pages by pressing the IN-
SERT/PARAM switch.
To assign a Plug-In or Hardware I/O on all
channels:
1 Follow steps 1–3 above.
2 Press OPTION/ALL+ASSIGN in the DSP
Edit/Assign area (or the SELECT switch beneath
the insert that you are editing).
To assign a Plug-In or Hardware I/O on all selected
channels:
1 Select channels by holding down SHIFT/ADD
and pressing SELECT on the channels.
2 Press ASSIGN in the DSP Edit/Assign section.
3 Follow steps 1–3 above.
4 Press OPTION/ALL+SHIFT/ADD+ASSIGN in
the DSP Edit/Assign section.
Editing Plug-In Parameters
When a plug-in insert is selected for editing, its
first page of control parameters is shown in the
HUI display. Individual parameters can then be
edited using the switches and V-POTs in the DSP
Edit/Assign section.
When the HUI is used to edit plug-in settings,
the associated track name is outlined in red in
the Pro Tools Mix window.
To edit an assigned Plug-In on a channel:
1 Select a plug-in insert using one of the three
methods described in “Selecting and Editing In-
serts and Plug-Ins” on page 54. The IN-
SERT/PARAM switch LED is lit, indicating the
display is in Parameter mode.
– or –
If you just finished assigning a plug-in on an in-
sert, press the INSERT/PARAM switch LED to en-
able Parameter mode (LED is lit), if necessary.
2 Rotate the SCROLL encoder pot to find the
plug-in parameter you want to edit.
3 Do one of the following:
◆ If the parameter is a switched parameter press
the SELECT switch under the parameter in the
display to toggle its state.
◆ If the parameter is continuously variable, or
has stepped values, rotate the V-POT encoder
under the parameter in the display to adjust its
setting. The LED ring around the V-POT indi-
cates parameter settings or levels. Numeric pa-
rameter values are shown in the display. If a
parameter amount exceeds four digits, the end
of the parameter value string is truncated.