Specifications
MIDI Control Surfaces Guide50
When only some of the plug-in inserts on a
channel are bypassed, pressing the INSERT
switch for the first time turns off bypass on all
plug-in inserts for the channel. Pressing the IN-
SERT switch a second time bypasses all plug-ins.
◆ To change the bypass status of all plug-in in-
serts on all channels, press OPTION/ALL+ any
INSERT switch.
◆ To change the bypass status of all plug-ins on
all selected channels, press OP-
TION/ALL+SHIFT/ADD+ any INSERT switch.
V-SEL Switch
The V-SEL (“V-POT SELECT“) switch serves sev-
eral functions:
◆ Assigns send or I/O routing for an individual
channel.
◆ Acts as a Send Mute switch when the Master
MUTE switch in the Select/Assign section is en-
gaged (LED is lit).
◆ Selects pre or post status for the send. While
in Flip mode, the V-SEL switch continues to
control send pre or post operation regardless of
the current state of the master MUTE/PREPOST
switch.
◆ Selects fader or V-POT to revert to default set-
ting, when used with the DEFAULT (Quick-
Mode) switch.
PAN/SEND V-POT Encoder
When used with the switches in the Select/As-
sign section, the PAN/SEND V-POT is used to
edit channel pan, send levels and send pan set-
tings (in Flip mode, explained later in this chap-
ter).
For fine adjustments, press the ALT/FINE switch
while turning a channel V-POT.
The V-POT is also used to assign send and I/O
routing for individual channels. See “DSP SE-
LECT Switches and V-POT Encoders” on
page 58.
The V-POT acts as a virtual knob, with LED ring
lights that represent the “knob value” for send
levels and pan settings. When showing send lev-
els, the V-POTs display a continuous series of
LEDs.
When showing pan position, an individual LED
from the ring lights to indicate relative pan po-
sition, while a special “6 o’clock” LED lights to
indicate a centered pan position.
The V-POTs audibly click when assigning send
and I/O destinations, as well as when editing in-
sert assignments and plug-in parameters in the
DSP Edit/Assign section. This audible click func-
tionality can be enabled or disabled by pressing
the F3 switch in the F-key switch section.
The Master BYPASS switch in the Select/As-
sign section functions differently from the
BYPASS switch in the DSP Edit/Assign sec-
tion. See “BYPASS Switch” on page 61.
V-SEL
PAN/SEND