Specifications
MIDI Control Surfaces Guide36
If “Insertion Follows Scrub/Shuttle” is not
selected:
■ Press SCRUB or SHUTTLE and turn the wheel
to keep your current selection and move the cur-
sor outside of the selection.
■ Press SHIFT/ADD and turn the wheel to clear
the current selection and create a new one. The
new selection starts wherever you first press
SHIFT/ADD.
■ Release SHIFT/ADD to move the cursor out-
side the new selection.
■ Press SHIFT/ADD additional times to trim the
new selection as needed.
Scrub/Shuttle Tips
◆ At any time during scrubbing or shuttling,
you can press the Left or Right Arrow to move
the current scrub position to the selection start
or end.
◆ You can freely move between scrub and shut-
tle modes. The current SCRUB or SHUTTLE po-
sition is retained.
◆ If you enter scrub or shuttle but don’t move
the wheel or mouse, you can exit Scrub or Shut-
tle mode without affecting the current selection.
To define a selection using a combination of
SCRUB or SHUTTLE functions:
1 Press SHUTTLE to enter Shuttle mode.
2 Shuttle along the timeline. When you get to
roughly the selection in-point, press
SHIFT/ADD.
3 Continue shuttling down the timeline. When
you get to roughly the out-point, release
SHIFT/ADD. Your “rough selection” is now de-
fined.
4 Press SCRUB to enter Scrub mode.
5 Press the Left Arrow key to move the scrub po-
sition to the selection start.
6 Press SHIFT/ADD (to retain the selection), and
scrub the selection in-point until you reach the
desired location.
7 Press the Right Arrow key to move the scrub
out-point to the selection end.
8 Press SHIFT/ADD (to retain the selection), and
scrub the selection out-point until you reach the
desired location.
Capturing Memory Locations
When working with Scrub and Shuttle func-
tions, you can do the following:
◆ Memory Locations can be captured at any
time by pressing the ENTER key on the HUI nu-
meric keypad.
◆ Press the Up Arrow to free the cursor without
capturing a Memory Location.
Keyboard Shortcuts Section
Save and Undo Switches
The UNDO switch will Undo or Redo the last
edit operation. Its LED is lit when Undo is avail-
able for use after an operation. Its LED flashes
when Redo is available.
The SAVE switch LED is lit if the session has
changed from its currently saved state.
UNDO SAVE
KEYBOARD SHORTCUTS