Specifications

Chapter 3: Mackie HUI Control Surface 33
Host Communication Status LED
When Pro Tools is communicating properly
with the HUI, the far-right decimal point LED in
the Time Code Display will flash.
Rude Solo Light
The Rude Solo Light flashes whenever there is at
least one channel in the current session that is
soloed.
Numeric Keypad
The Numeric Keypad is used for storing and re-
calling Memory Locations, data entry (such as
counter values), and confirming an editing op-
eration. It also supports all Numeric Keypad
modes (Classic, Transport and Shuttle) in the
Operation preferences.
◆ For dialog messages, press ENTER for OK, and
F8/ESC for Cancel.
◆ Press ENTER to enter numeric values into
Pro Tools counters or displays. Press F8/ESC to
cancel numeric entry and leave settings un-
changed.
◆ Press Forward Slash (/) to move between fields
for Start, End, and Length times in the Edit Win-
dow.
To define a Memory Location or Marker:
■ During playback or recording, press ENTER.
To recall a Memory Location or Marker:
■ Press the decimal key once.
■ Press a Memory Location or Marker number.
■ Press the decimal key again.
To Set Pre or Post Roll
■ Press ALT/FINE+PRE or POST, then enter val-
ues with the Numeric Keypad.
Scrub/Shuttle Wheel
This wheel controls Scrub and Shuttle func-
tions. Pressing the SCRUB and SHUTTLE
switches next to the Scrub/Shuttle wheel en-
ables each mode.
When used in conjunction with the Zoom/Nav-
igation/Selection switch quadrant, you can cre-
ate and adjust region selections with the
Scrub/Shuttle wheel.
Refer to the Pro Tools Reference Guide for de-
tails on Numeric Keypad modes.
-
+
CLR
*
=
/
789
456
123
0
E
N
T
E
R
.
LOCATE/NUMERICS
FAST FWD STOP PLAY
RECORD
REWIND
SCRUB
SHUTTLE