Specifications

MIDI Control Surfaces Guide32
To manually enter selection start and end times:
1 Press ALT/FINE+IN or OUT in the Audition
switch matrix.
2 Enter values on the numeric keypad. This en-
ters a Start or End time according to the
Grid/Time Display value used in Pro Tools.
3 Press the Left or Right Arrows to cycle through
the numeric fields in the Start and End counters
in the Pro Tools Transport window. Press the Up
or Down Arrows to increase or decrease the cur-
rent numeric field value. Press CLR to clear the
counters.
4 To confirm the entered time value, press the
ENTER switch. (To enter the same value for both
Start and End times, press the OPTION/ALL+EN-
TER).
– or –
Press the F8/ESC switch to abort numeric entry
and leave the times unchanged.
AUDITION Functions
To audition an edit point, press AUDITION and
PRE, IN, OUT or POST.
Playback continues until AUDITION is pressed
again or until another transport button is
pressed.
PRE Plays audio starting at the pre-roll point up
to the beginning of the selection.
IN Plays audio starting at the beginning of the
selection and lasting the length of the post-roll
amount.
OUT Plays audio starting before the selection
end point by the pre-roll amount.
POST Plays audio starting at the end of a selec-
tion and lasting the length of the post-roll
amount.
In addition, there are these shortcuts for audi-
tion functions:
◆ Press ALT/FINE+OPTION/ALL, and PRE or IN
to play audio starting at the pre-roll point, con-
tinuing through the selection start, and ending
after the selection start point by the post-roll
amount.
◆ Press ALT/FINE+OPTION/ALL and OUT or
POST to play audio starting before the selection
end point by the pre-roll amount, continuing
through the selection end point, and ending af-
ter the selection end point by the post-roll
amount.
Time Counter Display and
Rude Solo Light
This eight-character, seven-segment LED dis-
play shows the current session time position in
standard formats, as selected in the Pro Tools
software (you cannot select time formats with
HUI).
Three LEDs positioned next to the display indi-
cate the current time display mode:
◆ TIME CODE: SMPTE format
◆ FEET: Feet and Frames
◆ BEATS: Bars and Beats
◆ All indicator LEDs off: Minutes/Seconds or
Samples (depending on the Time Display mode
chosen)
TIME CODE
FEET
RUDE
SOLO
LIGHT
BEATS