Specifications

MIDI Control Surfaces Guide22
For example, rotate the Rotary Selector to select
Send A, “SA,” and press a channel’s MULTI
switch to mute Send A on that channel. The
green LED in the channel’s MULTI switch indi-
cates that Send A is muted. Use the Rotary Selec-
tor to select other sends to mute or unmute.
Flip Mode for Sends
In Flip mode, the channels faders and mutes
then “flip” to become the send level and mute
controls. The top row of the LCD displays the
Send assignments and the MULTI switches con-
trol the send pre- and post-fader settings.
To enter Flip mode:
1 Rotate the Rotary Selector so that the Rotary
Pots are controlling sends.
2 Press the Rotary Selector.
3 Pressing a channel’s MULTI switch will toggle
the Send between pre- and post-fader. The chan-
nel MULTI switch LED is lit when the Send is
pre-fader, and the it is not lit when the Send is
post-fader. The LCD will briefly display “Pre” or
“Post” when toggling between these two set-
tings.
4 Move the channel faders to control pre or post
levels for Sends.
5 Use the channel MUTE switches to mute
sends.
6 Rotate the Rotary Selector to control any of
the other sends in Flip mode.
To exit Flip mode:
■ Press the selector to return to Rotary Pot con-
trol.
Automation
To enable Automation:
1 Press the AUTO ENBL switch to display the au-
tomation enable choices in the LCD.
2 The SELECT switch LEDs below the LCD show
the current enable states. Press any of the SE-
LECT switches below the LCD to make a selec-
tion.
3 Press the AUTO ENBL switch to exit.
Automation Mode
To enter Automation mode:
1 Press SHIFT+MODE to display the current Au-
tomation mode choices in the LCD. The SELECT
switch LEDs below the LCD show the current
mode.
2 Rotate the Rotary Pots to make a selection.
3 Press the ALL switch and rotate a Rotary Pot to
change all channels to the same state.
If your are playing back Pro Tools automation
tracks while in Punch or Latch automation
mode, you can Punch In a fader by pressing the
BURN switch above that fader. The BURN
switch LED will light and remain lit as long as
the fader motor is disengaged. To Punch Out the
fader, press the BURN switch again. The LED
will go out and the motor will engage.
Suspend Automation
To globally suspend playback and recording of
automation:
■ Press SUSPEND. The SUSPEND switch LED
will start flashing.
Pan settings and channel plug-in bypasses
cannot be accessed while in Flip mode.