Multi Stream Transport (MST) Hub CSV-5300 Page 1 of 6
Introduction The DisplayPort (DP) Multi-Stream Hub which appears one DP1.2 (HBR2) input and multiple dual mode DP outputs for supporting multi-monitors application. The most noticeable enhancement is this MST Hub can let end user enjoy the one big picture with multiple monitors or independent pictures respective. Maximum resolution supports up to 4K x 2K, and RX and TX ports are protected with the highest security built-in circuitry fully compliant with the industry standard HDCP 1.3.
# # Package contents Before installation, check the items in the package. The package should contain the following items: • DP Multi-Stream Hub • Power adapter • Power cord • Setup Poster # Key features • Standard compliance with DisplayPort 1.2 / 1.1a, HDMI1.4a, VESA DDM and EDID1.4 • One DP 1.2 input and multiple DP++ output • Supports main link rate up to 5.
Application diagram # Resolutions / Refresh rate # Display Mode DP 1.2 ouput port 1 DP 1.2 output port 2 DP 1.
Quick setup guide #*The Reset key only use when the PC does not recognise the HUB device. Troubleshooting Here are the steps to solve possible problems. Scenario: No video on any downstream monitor connected: 1. Check the LED to make sure the hub has power. Use only the power adapter that was provided with the hub. 2. Check that each downstream monitor is powered on. 3. Check the DisplayPort cable to be sure it is connected to the computer and hub.
Scenario: Same image appears on all downstream ports: 1. Check the computer or graphics card user manual to confirm that DisplayPort 1.2 and a multi-stream video signal are supported. 2. Check the Windows Display Control Panel to confirm that all downstream monitors are set for extended mode. 3. Update the video driver to the latest version available to enable the multi-stream functionality.
