Instructions

Resolutions / Refresh rate
#
#
Recommend system requirements
The DP Multi-Stream Hub requires the following:
Computer that supports DisplayPort 1.2 with multi-stream support*
! Microsoft Windows:
#
-Windows 7 SP1 (32-bit or 64-bit editions)
-Windows 8 (32-bit or 64-bit editions)
*Use of the DP Multi-Stream Hub with a computer that does not meet this specification is not supported.
Quick setup guide
*The Reset key only use when the PC does not recognize the HUB device.
#
Troubleshooting
Here are the steps to solve possible problems.
Scenario: No video on any downstream monitor connected:
1. Check the LED to make sure the hub has power. Use only the power adapter that was provided with the
hub.
2. Check that each downstream monitor is powered on.
#
#
#
#
#
#
Display Mode
DP 1.2 output port 1
DP 1.2 output port 2
Single
3840x2160@60H, 24bpp
Not connected
Single
Not Connected
3840x2160@60H, 24bpp
Dual
2560x1600@60Hz, 24bpp
2560x1600@60Hz, 24bpp
Page  of 4 5