Multi Stream Transport (MST) Hub CSV-5200 Page 1 of 5
Introduction The DisplayPort (DP) Multi-Stream Hub which appears one DP1.2 (HBR2) input and multiple dual mode DP outputs for supporting multi-monitors application. The most noticeable enhancement is this MST Hub can let end user enjoy the one big picture with multiple monitors or independent pictures respective. Maximum resolution supports up to 4K x 2K, and RX and TX ports are protected with the highest security built-in circuitry fully compliant with the industry standard HDCP 1.3.
# # Package contents Before installation, check the items in the package. The package should contain the following items: • DP Multi-Stream Hub • Setup Poster # Key features • Standard compliance with DisplayPort 1.2 / 1.1a, HDMI1.4a, VESA DDM and EDID1.4 • One DP 1.2 input and multiple DP++ output • Supports main link rate up to 5.
Resolutions / Refresh rate # # Display Mode DP 1.2 output port 1 DP 1.2 output port 2 Single 3840x2160@60H, 24bpp Not connected Single Not Connected 3840x2160@60H, 24bpp Dual 2560x1600@60Hz, 24bpp 2560x1600@60Hz, 24bpp Recommend system requirements The DP Multi-Stream Hub requires the following: Computer that supports DisplayPort 1.
#3. Check the DisplayPort cable to be sure it is connected to the computer and hub. Use only the DisplayPort cable that was provided with the hub for the connection to the computer. 4. Check the computer or graphics card user manual to confirm that DisplayPort 1.2 and a multi-stream video signal are supported. 5. Check the Windows Display Control Panel to confirm that the downstream monitors attached to the hub have been detected and enabled. Scenario: No video on some downstream monitors connected: 1.
