Specifications

TH82 Series Reference Manual
67/67
APPENDIX A DIP SWITCH
SETTING & CHECKING THE DIP SWITCHES
No. CONTENTS STATUS STATUS
1
Reset By Dtr Signals Off Invalid On Valid
2
(Reserved) Off (Fixed to OFF) (Fixed to OFF)
3
Protocol Off XON/XOFF On DTR/DSR
4
Baud Rate Off 9600 On 19200
5
Off Off On On
6
Parity
Off
Non
On
Even
On
Non
Off
Odd
7
Data Length Off 8bits On 7bits
8
Busy Off Bufferful On Bufferful/Offline
9
Reversed Off Fixed to Off Fixed to Off
10
Carriage Return Off Valid On Invalid
Before changing DIP switch setting
1: Make sure that Power of the printer is turned off.
2: Remove the rubber cap at the bottom of the printer.
3: Change the status of DIP switch by using something with a point.
4: Cover the DIP switch with the rubber cap.
CAUTION
The new status becomes effective when the printer power is turned on.
DIP SWITCH POSITION
DIP SWITCH
ON
OFF
Rubber Cap