Specifications
TH82 Series Reference Manual
60/60
GS a Enable/disable Automatic Status Back
[FORMAT] <1D>H<61>H<n>
[RANGE]
0≦n≦255
[FUNCTION] *Enable or disable Automatic Status Back (ASB) and select the status.
Value
Bit Status
0 1
0 Drawer kick-out connector Disabled Enabled
1 Online/offline status Disabled Enabled
2 Error status Disabled Enabled
3 Paper roll sensor status Disabled Enabled
4 Undefined - -
5 Undefined - -
6 Undefined - -
7 Undefined - -
[CAUTION] *If any of the status in the table above are enabled, the printer transmits the status when this
command is executed. The printer subsequently transmits the status automatically whenever the
enabled status changes. In this case, the disabled status of ASB may change because each status
transmission indicates the current status.
*If all the status are disabled, the ASB function is disabled.
*The following four status bytes are transmitted without confirming if the HOST is ready to receive
data.
*The four status bytes must be continuous except the XOFF code.
*Because this command is executed after the data is processed in the print buffer, there may be a
time lag between data reception and status transmission, depending on the receive buffer status.
*The following tables are the status which should be transmitted.
a: First byte (printer information)
Value
Bit Status
0 1
0 Not used Fixed to 0
1 Not used Fixed to 0
2 Drawer kick-out connector(*1) Low High
3 Online/offline status Online Offline
4 Not used Fixed to 1
5 Cover status(*2) Closed Open
6 Paper feeding by the PAPER FEED button(*3) Not feeding Feeding
7 Not used. Fixed to 0
*1: Refer [CAUTION] e.
*2: Open by using cover open knob.
*3: The status is offline during paper feeding by the PAPER FEED button.