Specifications

TH82 Series Reference Manual
56/56
GS P Specify basic calculate pitch
[FORMAT] <1D>H<50>H<x><y>
[RANGE]
0≦x≦255
0≦y≦255
[FUNCTION] *Specifies the horizontal and vertical motion units to approximately 25.4/xmm{(1/x) inches} and
approximately 25.4/ymm{(1/y) inches}.
*When x = 0, the default setting of horizontal motion unit is used.
*When y = 0, the default setting of vertical motion unit is used.
[DETAILES] *The horizontal direction is the perpendicular direction to the paper and the vertical direction is the
paper feed direction.
*The following commands are used, regardless of the character rotation (upside-down or 90°
clockwise rotation), in standard mode.
① Commands using x: ESC SP, ESC $, ESC ╲ , FS S, GS L, GS W
② Commands using y: ESC 3, ESC J, GS V
*The following commands are used depending on the character orientation in page mode.
① When the print starting position is specified to the upper left or lower right by ESC T
(data is buffered in the perpendicular direction to the paper feed direction.)
*Commands using x: ESC SP, ESC $, ESC W, ESC ╲, FS S
*Commands using y: ESC 3, ESC J, ESC W, GS $, GS ╲ , GS V
② When the print starting position is specified to the upper right and the lower left by
ESC T. (data is buffered in the paper feed direction.)
*Commands using x: ESC 3, ESC J, ESC W, GS $, GS ╲
*Commands using y: ESC SP, ESC $, ESC W, ESC ╲ , FS S, GS V
*This command does not affect the previously setting values.
*The calculated result from combination width other commands is truncated to the minimum value
of the mechanical pitch.
[DEFAULT] x=180、y=360
GS V Cut paper
[FORMAT] <1D>H<56>H<m>
<1D>H<56>H<m><n>
[RANGE]
① 0≦m≦3, 48≦m≦51
② 65≦m≦68, 0≦n≦255
[FUNCTION] Executes cutting paper specified as follows.
[CAUTION] *This command is effective only when processed at the beginning of a line.
* Paper must be fed 3 mm after printing to prevent paper jam.
m Function
① Full cut (one point left uncut)
② Feeds paper (cutting position＋n × vertical motion unit) and cuts the paper
fully (one point left uncut).