Specifications

TH82 Series Reference Manual
51/51
GS $ Set absolute vertical print position in page mode
[FORMAT] <1D>H<24>H<nL><nH>
[RANGE]
0≦nL≦255、1≦nH≦255
[FUNCTION] Sets the absolute vertical print position which is based on the starting position in page mode.
The absolute print position is set to [(nL + nH x 256) x (horizontal or vertical motion unit)].
[CAUTION] *This command is valid only in page mode.
*This command is ignored when the setting of the absolute print position exceeds the specified
printing area.
*The horizontal starting buffer position does not move.
*The reference starting position is specified by ESC T.
*This command operates as follows depending on the starting position specified by ESC T.
① When the starting position is set to the upper left or lower right, this command sets the
absolute print position to the vertical direction. In this case, the vertical motion unit, y, is
used.
② When the starting position is set to the upper right or lower left, this command sets the
absolute print position to the horizontal direction. In this case, the horizontal motion unit,
x, is used.
*The horizontal and vertical motion unit are specified by GS P.
* The calculated result is truncated to the minimum value of the mechanical pitch.
GS * Define download bit image
[FORMAT] <1D>H<2A>H<n1><n2><d1>….<dn>
[RANGE]
1≦n1≦56
1≦n2≦48
n1Xn2≦1344
n=n1xn2x8
[FUNCTION] Defines a download bit image of the number of dots specified by n1 and n2.
[CAUTION] *The number of dots in the horizontal direction is n1 x 8 and in the vertical direction is n2 x 8.
*dn: Bit image data
*The download bit image is effective until the printer is re-defined, initialized, reset or the power is
turned off.
*Both of the download bit image and download character cannot be defined at the same time. The
defined download character is cleared by executing this command.
n1x8 dots
D1
― ― ― ― ― ― ― ―
MSB
LSB
D2 ― ― ― ― ― ― ― ―
MSB
LSB n2x8dots
Dn2 ― ― ― ― ― ― ― ―
MSB
LSB